Carrier VVT Zone Installation And Startup Manual

Contents

Carrier VVT Zone Installation And Startup Manual Manual pdf 69 page image

VVT Zone Controller 65AlarmsNavigation: i-Vu / Field Assistant:BACview:Properties > Equipment > AlarmsHOME > ALARMPoint Name/Description RangeSpace Temperature – Indicates if the space temperature exceeds the high or low alarm limit. R: Normal/AlarmAlarming Temperature – Indicates the space temperature value that caused the spacetemperature alarm. This value is only displayed when the Space Temperature alarm (above)is in Alarm.R: -56 to 245°FAlarm Limit Exceeded – Indicates the value of the space temperature alarm limit thatcaused the space temperature alarm condition. Value is only displayed when the SpaceTemperature alarm (above) is in Alarm.R: -56 to 245°FSpace Temp Sensor – Indicates if the space temperature sensor fails. R: Normal/AlarmIndoor Air Quality – Indicates if the occupied CO2 R:level exceeds the Occupied High CO2Alarm Limit.Normal/AlarmSupply Air Temperature – Indicates if the supply air temperature exceeds the hightemperature alarm limit or drops below the low temperature alarm limit.R: Normal/AlarmFilter – Indicates if the filter's runtime hours exceeds the runtime alarm limit. R: Clean/DirtySpace Relative Humidity – Indicates if the relative humidity exceeds the high RH alarm limit. R: Normal/AlarmNetwork OAT - Indicates if the controller is not receiving a valid OAT value over the network. R: Normal/AlarmAirside Linkage Status – If the controller is the VVT Master, Alarm indicates that it lostLinkage communications with the air source. If the controller is a slave, Alarm indicates thatit lost Linkage communications with the VVT master.R: Normal/AlarmLinkageNavigation: i-Vu / Field Assistant:BACview:Properties > Equipment > LinkageHOME > CONFIG > LINKAGEPoint Name/Description Default/RangeAirside LinkageClick Linkage Collector/Linkage Provider to access the microblock popup's Summaryand Details tabs. See the microblock popup's Help files for more detailedexplanations.Linkage Collector – Set the Number of Providers to the total number of controllers inthe linked system, including the bypass and VVT Master.D:R:11 to 32