Carrier VVT Zone Installation And Startup Manual

Contents

Carrier VVT Zone Installation And Startup Manual Manual pdf 55 page image

VVT Zone Controller 51NOTE Engineering units shown in this document in the defaults and ranges are strictly for reference. Youmust enter an integer only.Statusi-Vu / Field Assistant:Navigation:BACview:Properties > Equipment > StatusHOME > STATUSPoint Name/Description RangeTerminal Mode R:– The controller's current operating status. OFFHEATINGWARM-UPVENTCOOLINGDEHUMIDFYREHEATPRESSURIZEEVACUATESHUTDOWNIAQ OVERRIDEAIR BALANCINGTerm Type R:– The type of zone terminal that the controller is installed on. Single DuctParallel FanSeries FanSpace Temperature - Prime Variable R:– The space temperature value currently used forcontrol.-56 to 245°FDamper Position R:– The current damper position. 0 to 100%Supply Air Temperature R:– The current supply air temperature. -56 to 245°FHeating Capacity R:– The current reheat capacity when the zone is configured for reheat. 0 to 100%Baseboard Heating Capacity R:– The current modulating baseboard heat capacity whenthe zone is configured for Combination Baseboard and Ducted Heat.0 to 100%Outdoor Air Temperature R:– The current outdoor air temperature from a linked airsource, if available, or from another network source.-56 to 245°FFan – The status of the terminal fan if Term Type is Parallel Fan or Series Fan R:. On/OffCO2 (ppm) – The current IAQ value if Optional Sensor Type is set to IAQ Control R:. 0 to 5000ppmSpace Relative Humidity – The current space relative humidity if Optional Sensor Typeis set to RH ControlR:.0 to 100%rhShutdown – When Active D:, disables all control functions, at normal equipment timedelays and close the damper. R:InactiveInactive/ActiveAppendix A: VVT Zone Controller Points/Properties