Casio Algebra FX 2.0 PLUS User Manual

Also see for ALGEBRA FX 1.0 Plus: User guide Software guide Manual Manual Manual

20010101u To create an EA-100 setup using Setup WizardBefore getting started...• Before starting the procedure below, make sure you first decide if you want to startsampling immediately using the setup you create with Setup Wizard, or if you want tostore the setup for later sampling.• See sections 4-3, 4-4, and 4-5 of this manual for information about procedures required tostart sampling and to store a setup. We recommend that you read through the entireprocedure first, referencing the other sections and pages as noted, before actually tryingto perform it.• To terminate Setup Wizard part way through and cancel the setup, press !i(QUIT).1. Display the E-CON main menu.2. Press 1(SETUP). This displays the “Setup EA-100” sub-menu.3. Press b(Wizard). This displays the Setup Wizard initial screen.4-2-2EA-100 Setup4. Press any key to start Setup Wizard and display the sensor specification screen.• Press 1 to specify a CASIO sensor, or 2 to specify a VERNIER sensor. From themenu of supported sensors that appears, select the one you want.5. The screen that appears after you select a sensor in step 4 depends on whether or notyou specified “Photogate” as the sensor.• If you did not specify “Photogate,” a screen for setting the sampling interval appears afterstep 4.1. Use the number keys to input the sampling interval.• Inputting a value in the range of 0.52 to 300 enables real-time sampling. Inputtinga value outside this range enables non-real-time sampling.2. Press w.• If you specified “Photogate” as the sensor, a screen for setting the sampling timingappears after step 4.1. Press either 1(Open) or 2(Close) to specify the sampling timing. Pressing eitherkey advances to a screen for setting the time recording method.• See online help (GATE TRIGGER STATUS HELP) for details about the Open andClose settings.2. Press 1(Abs) or 2(Rel) to specify the sampling time recording method.