Casio CTK-6200 User Manual

Also see for CTK-6200: Guidelines User guide

Contents

Casio CTK-6200 User Manual Manual pdf 16 page image

Selecting and Playing a ToneE-14■ To disable Auto Power Off1. While the Digital Keyboard is turned on, pressthe L-1 (POWER) button to turn it off.2. While holding down the L-3 ([A] POPS/ROCK/DANCE) button, press the L-1 (POWER) buttonto turn on the Digital Keyboard.• Auto Power Off will be disabled at this time.• Turning off the keyboard after performing the above stepswill re-enable Auto Power Off.1. While holding down the L-17 (ACCOMP ON/OFF) button, press the L-16 (PLAY/STOP)button.• This starts demo tune play.• The Digital Keyboard has a total of five demo tunes.You also can use the R-14 (–, +) buttons to select ademo tune.• Pressing the L-14 (dFF) button performs fast forwardplay of the demo tune, while the L-13 (sREW) buttonperforms fast backward play. Holding down the L-13(sREW) button until playback reaches the beginningof the current song will stop playback there. Normalplayback will resume when you release the L-13(sREW) button. Holding down the L-14 (dFF)button continues fast forward playback, even after theend of a song is reached.• You can play along on the keyboard with demo tuneplay. Note, however, that you cannot change the toneassigned to the keyboard. Only the key operationsdescribed above are supported during demo tuneplayback.2. To stop demo tune playback, press the L-16(PLAY/STOP) button.The tones of this Digital Keyboard are divided among groups,each of which corresponds to one of the 12 TONE buttons.You can specify a tone by its group and its tone number.Use the following procedure to select a single tone that isapplied across the entire keyboard.1. Refer to the separate “Appendix” to look up thegroup and the number of the tone you want toselect.2. Check to make sure that the @ and Aindicators are not on the display.• If they are displayed, press the R-19 (SPLIT) buttonand/or R-20 (LAYER) button to clear both indicatorsfrom the display.3. Use buttons R-1 ([A] PIANO) through R-12 ([L]USER TONES) to select a tone group.• The R-12 ([L] USER TONES) button selects the usertone group. For details, see “Using the Tone Editor”(page E-44).4. Use the dial to scroll through the tone numbersuntil the one you want is displayed.Example: Group [C], Number 006Listening to Demo TunesSelecting a ToneTo select a toneTone name GroupNumber