Using the Tone EditorE-47The table below shows the parameters that can be configured on the tone editor screen. For information about each parameter,also refer to “Tone Creation Overview” (page E-44).The settings marked with an asterisk (*) in the “Setting Range” column are initial defaults.Tone Parameter SettingsParameter Name Description Setting RangeAttackTime(Attack Time)Specifies the time until a note starts to sound after a key is pressed. –64 to 0* to +63ReleasTime(Release Time)Specifies the time a note continues to sound after a key is released. –64 to 0* to +63CutOff(Cutoff Frequency)Adjusts timbre by attenuating note components that are higher than a certainfrequency. A larger value produces a brighter, harder sound, while a lowervalue produces a mellower, softer sound.–64 to 0* to +63Vib.Type(Vibrato Type)Specifies the vibrato type (vibrato waveform). Sin*, Tri, Saw, SqrVib.Depth(Vibrato Depth)Specifies how much vibrato is applied to a note. –64 to 0* to +63Vib.Rate(Vibrato Rate)Specifies the speed of the vibrato applied to a note. –64 to 0* to +63Vib.Delay(Vibrato Delay)Specifies how much time elapses until vibrato starts. –64 to 0* to +63Oct.Shift(Octave Shift)Shifts the pitch upwards or downwards in octave steps. –2 to 0* to +2Volume(Volume)Specifies the volume level of all tones. A larger value sets a higher volumelevel.0 to 127*TouchSense(Touch Sense)Specifies how much the volume changes in accordance with the relativeamount of pressure applied to keyboard keys. A larger positive value resultsmore change in volume in accordance with key pressure. A larger negativevalues results in less change in volume in accordance with key pressure. Keypressure does not affect volume when a value of 0 is set.–64 to 0 to +63*Rev.Send(Reverb Send)Specifies how much reverb is applied for each tone. 0 to 40* to 127Cho.Send(Chorus Send)Specifies how much chorus is applied for each tone. 0* to 127Setting Description WaveformSin Sine waveTri Triangle waveSaw Sawtooth waveSqr Square wave