20051101u To start sampling1. Start the sampling operation by performing one of the function key operations describedbelow.✔ If the final Setup Wizard screen (page 2-4) is on the display, press b(Start Setup).✔ If the Advanced Setup menu (page 3-1) is on the display, press 1(STRT).✔ If the E-CON2 main menu (page 1-1) is on the display, press 4(STRT).• After you perform any one of the above operations, a sampling start confirmation screenlike the one shown below will appear on the display.2. Press w.• This sets up the EA-200 using the setup data in the current setup memory area.• The message “Setting EA-200...” remains on the display while EA-200 setup is inprogress. You can cancel the setup operation any time this message is displayed bypressing A.• The screen shown below appears after EA-200 setup is complete.8-2Starting a Sampling Operation3. Press w to start sampling.• The screens that appear while sampling is in progress and after sampling is completedepend on setup details (sampling mode, trigger setup, etc.). For details, see“Operations during a sampling operation” below.u Operations during a sampling operationSending a sample start command from the calculator to the EA-200 causes the followingsequence to be performed.Setup Data Transfer → Sampling Start → Sampling End →Transfer of Sample Data from the EA-200 to the CalculatorThe table on the next page shows how the trigger conditions and sensor type specified in thesetup data affects the above sequence.
