Important information• The luminaire and heat alarm must be installed in accordancewith local wiring regulations if in doubt seek advice from aqualified electrician.• Before installing or completing maintenance work on theluminaire and heat alarm make sure the mains poweris switched off.• The luminaire and heat alarm is designed for indoor use only.• The luminaire is dimmable, a trailing-edge dimmer must beused.• The light source of this luminaire is not replaceable; when thelight source reaches its end of life the whole luminaire mustbe replaced.• The luminaire is fire rated 30/60/90 minutes underEN1365- 2014 fire test.• The driver provided is the only driver that can be used withthis luminaire.• The heat alarm can only be installed within the Lumi-Pluginluminaire and not as a single unit.• The heat alarm is powered by mains power (110-230V AC),with a CR2 lithium back-up battery.• The heat alarm can be RF interlinked with other alarms in theCAVIUS Wireless Family.• The Maximum number of alarms that can be interlinked withina house group is 32.• The distance between interlinked alarms depends on the houselayout and should always be tested after installation. It is notadvised to install alarms with a separation of more than 10m.• The best areas to install the heat alarms:• Areas not suitable for smoke alarms due to high risk offalse alarms• Kitchen area• Bathroom• Garage or workshop• Do not install the heat alarms:• In rooms where the temperature goesoutside -10oC to +50oC.• Bedrooms• Lounge• Dining room• Hallway• Family roomInstallation and Specification SheetLP120 Main Powered Heat Alarm DownlightDownlight specificationBrand: Lumi-PluginAvailable Colours: White or ChromeIP Rating: IP65Material: Mixed (Metal and Plastic)Input Voltage to luminaire 16VInput Voltage to Driver 220V - 240V 50/60HzPower Output: 9.5WColour Temp: 4000K or 2700KLight Colour: Cool White or Warm WhiteDimmable: YesFire Rating: 30/60/90Luminaires per pack: 1Product Diameter: 120mmProduct Depth: 70mmHours: 50,000Lumens: 700LBeam Angle: 60°Heat alarm specificationBrand: Lumi-PluginBattery Type: Replaceable CR2Operation AC/DC: 110V AC, 230V ACRange: Minimum 100m in open fieldPower Consumption: 161mAh in non-alarm conditionInterlink Frequency: 868MHZSound: Audible indicator min 85dB @ 3meter in anechoic successive tones5 YearWarranty550,000Hours16V CE MarkBeam Angleis 60°Fire Rated30/60/90Dimmable 700LumensDriverIncludedLP120WH/WARM/MBR/HA - LP120WH/COOL/MBR/HA