DèLonghi ESAM6600 Instructions For Use Manual

Contents

14Please note!if you use pre-ground coffee, you can only make one cup ofcoffee at a time.1. Press the button (fig. 2) repeatedly until “readyPre-ground” flashes on the display.2. Put one level measure of pre-ground coffee into thefunnel (fig. 13).3. Place a cup under the coffee spouts.4. Press the 1 cup or button (fig. 12).5. Preparation begins.after using the machine with pre-ground coffee, to go back tomaking coffee using beans, deactivate the pre-ground coffeefunction by pressing the button again to enable thecoffee mill.MAKING DRINKS WITH MIlKPlease note!a few seconds may elapse between energy saving mode anddelivery of the first drink.Filling and attaching the milk container1. Turn the lid of the milk container clockwise until itbecomes noticeably difficult to turn, then remove (fig.14).2. Fill the milk container with a sufficient quantity of milk,not exceeding the MAX level marked on the handle (fig.15).Please note!• For a denser more even froth, you must use skimmedor partially skimmed milk at refrigerator temperature(about 5°C). To avoid producing milk with poor froth orlarge bubbles, always clean the milk container lid and hotwater nozzle as dPribed in the section “Cleaning the milkcontainer” and “Cleaning the hot water/steam nozzle”(page 16).3. Make sure the milk intake tube is correctly inserted in thebottom of the milk container lid (fig. 16).4. replace the milk container lid and turn anticlockwise asfar as it will go.5. remove the hot water spout from the nozzle (fig. 17).6. attach the container to the nozzle and push as far as itwill go (fig. 18). The machine emits a beep (if the beepfunction is active).7. place a sufficiently large cup under the coffee spouts andfrothed milk spout.To use particularly tall cups/glasses, raise the lid of thecompartment in the cup tray (fig. 19).Making cappuccino1. after attaching the milk container, position the containerpointer on 1 “ CaPPuCCino” printed on the milk containerlid (fig. 20).The quantity of froth can be adjusted during delivery bymoving the pointer slightly towards 2 “MaCChiaTo” for adenser froth.Moving it towards 1 “CaPPuCCino” obtains a less densefroth.2. Press the CaPPuCCino button (fig. 21). The message“CaPPuCCino ConTainer PoinTer in PoSiTion 1”appears. (after a few seconds, frothed milk flows out ofthe milk spout into the cup below. Milk delivery stopsautomatically and coffee delivery begins).Please note:if during delivery you want to stop making milk or coffee, pressthe CAPPUCCINO button again.Making macchiato1. after attaching the milk container, position the containerpointer (B1) on 2 “laTTe MaCChiaTo” (fig. 22) printed onthe milk container lid.2. Press the lATTE MACCHIATO button (fig. 23). Themessage “laTTe MaCChiaTo ConTainer PoinTer inPoSiTion 2” appears. after a few seconds, frothed milkflows out of the milk spout into the cup below. Milkdelivery stops automatically and coffee delivery begins.Please note:if during delivery you want to stop making milk or coffee, pressthe lATTE MACCHIATO button again.Making caffelatte1. after attaching the milk container, position the containerpointer on “3 CaFFelaTTe” (fig. 24) printed on the milkcontainer lid.2. ress the CAFFElATTE button (fig. 25). The message“CaFFelaTTe ConTainer PoinTer in PoSiTion 3” appears.after a few seconds, milk is delivered from the milk spoutinto the cup below. Milk delivery stops automatically andcoffee delivery begins.Please note:if during delivery you want to stop making milk or coffee, pressthe CAFFElATTE button again.Making frothed milk and hot milk (WITHOUT COFFEE)1. after attaching the milk container, position the containerpointer (B1) according to the quantity of froth you require(pos. 3 caffelatte = little froth; pos. 1 cappuccino = fullerfroth).- froth