31llowing is an explanation of correcttion methods, cleaning and partsing. Please always refer to thisn when wanting to inspect or repairehicle.● Check that the fluid level is above theLOWER level mark with the motor-cycle in an upright position.● Brake fluid must be added to thereservoir whenever the fluid levelbegins to reach the LOWER levelmark.1. Remove the screws.2. Clean dust and other foreign materialsaround reserve tank to prevent foreignmaterials from falling inside tank.3. Remove the screws and take oil cupcap, diaphragm plate, diaphragm off.4. Replenish recommended brake oil tothe upper level inside reserve tank.RECOMMENDED BRAKE OIL ISDOT 3 or DOT 45. After replenishing bralce oil and whenassembly, pay attention to assemblydirection and jammed of diaphragm.Install in the reverse order of removal.NTENANCE PRECAUTIONSCAUTIONlways observe safety rules whenrforming maintenance on thehicle.hoose a flat surface and make suree main stand is in a secure downsition.se correct tools.onduct engine maintenance withe engine key out of the ignition.e careful around the engine anduffler when performing mainte-nce as these areas can becometremely hot.fter self maintenance, the wasteaterial must be packed in theecified container and entrustedsposal to the authorized disposalmpany.REPLENISHING FRONT / REARBRAKE FLUIDSCREWSOIL CUP CAPDIAPHRAGM PLATEDIAPHRAGMUPPER LEVEL