200GBThe installation menu has 4 sub-menus:• Programming,• Recognit. check,• Erase,• Test mode.Press the receiver card “PROGRAM” button to access the installation menu.The receiver exits the installation menu in the following cases:• if the “EXIT” option is selected at the end of the installation menu,- when the receiver box is closed and the tamper system activated,- if the t and OK buttons are not pressed for 5 minutes.3.3 Dip switches for parameter selection3.4 Accessing the installation menu(1) Using the receiver in tamper disabled mode means it is no longer compliant with IEC 79-2Book 2.IMPORTANT: the menu can only be accessed if the receiver box is open and if DIP1-1 (seeprevious page) is positioned so as to disable the tamper system.IMPORTANT: the receiver has 6 different languages and the factory-programmed language isEnglish. The first operation to be performed is to select the language.IMPORTANT: do not forget that, as well as the DIP1-2 settings, the armed input operatingmode (ARS) requires the parameters in the “arm input” menu to be suitably configured (seepage 218).DIP1-2 Arm input operation (ARS)Input designed for positive voltage operation (factory setting)Input designed for negative voltage operationDIP1-1 Tamper protection againstopening/removalTamper control enabled(factory setting)Tamper control disabled (1)Installing mode >ProgrammingInstalling mode >Recognit. checkInstalling mode >EraseInstalling mode >Test mode