DAITEM 785-21X Installation Manual
                                          | |
Contents
| 
It is possible to manage hardwired systemarming/disarming using wireless control devices(remote controls and keypads) and a specific outputif the control panel is fitted with an input. To adapt this command,the closed or open status of the relay can be associated with the disarmedstatus (OFF on control devices).214GB5.8.1 Disconnected with relay closed (OFF = closed)In this configuration, the receiver changes the status of the closed relay on receipt of the OFFcommand sent by the control devices.5.8.2 Disconnected with relay open (OFF = open)In this configuration, the receiver changes the status of the open relay on receipt of the OFFcommand sent by the control devices.Connection relay operation can be changed via the “Programming” menu and the “Conn. Relay”sub-menu in “Installation” mode.Example: to change connection relay operation so that the contact is open and not closed.1. Select the menu as shown below in order to identify the relay to be changed:Installing mode >ProgrammingProgramming >Arm Output5.8 Operating modes for control panel arm/disarm relay (RAC)5.9 Changing control panel arm/disarm relay operationIMPORTANT: the relay is factory-programmed with its closed status corresponding to the OFFcommand sent by the control devices.IMPORTANT: the Connection output is factory-programmed for “OFF = closed” (relay contactclosed on receipt of disarm/OFF command).OKInstalling mode >ProgrammingtProgramming >Language selecttttProgramming >RecognitionProgramming >Zone OutputsProgramming >Tamper OutputtProgramming >Fault OuputOKProgramming >Arm OutputArm OutputOFF = Closed |
Related manuals for DAITEM 785-21X
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine