DAITEM 785-21X Installation Manual
                                          | |
Contents
| 
8. Use221GBWhen the receiver is being used normally (user mode) or when it is in test mode, the screendisplays the consultation menu indicating the receiver statuses.The different receiver statuses are displayed in the following order1. Zones with activated alarms,2. Tamper alarms,3. Fault alarms,4. List of events.If none of the events above are listed, the screen displays a general message indicating its status.However, when there are events listed, the screen displays these events.Example 1: there is no event indicated by the receiver; the message displayed to indicate thissituation depends on the configuration.USER MODEThe receiver does not use wireless control devicesModule readyThe receiver does have wireless control devices and the system is armed.System armedThe receiver has control devices and the system is disarmed.System not armedExample 2: only one type of event – Active Zones – is indicated.Nothing happens when the t button is pressed. However, if the OK button is pressed, thescreen displays the sub-menu with details relating to the activated detectors (see page 224).One or several receiver zones have triggered an alarm.Active zones >Example 3: several situations are listed: Active Zones, (highest priority), Faults and List of Events(lowest priority).1. Press the t button to continue consulting the other information listed.One or several receiver zones have triggered an alarm and other information is alsoprovidedActive zones >Others ...2. Press the t button to continue consulting the other information listed.Une ou plusieurs anomalies sont présentes dans le système.Fault >Others ...3. If the t button is pressed again, the screen redisplays the list of information from the top.La liste contient de nouveaux événements.Read Events >Others ...8.1 Consultation menu |
Related manuals for DAITEM 785-21X
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine