DCS BGA131 Use And Care Manual

Contents

DCS BGA131 Use And Care Manual Manual pdf 16 page image

15TROUBLESHOOTINGBurner won’t light when the ignitionis pushed.Burner flame is yellow or orange, inconjunction with the odor of gas.Low heat with knob in “HI” position.Remove the burner grate. With the control knob in the “OFF”position, watch the electrode while engaging the ignition.You should see a spark jump inside the electrode cap.If there is no spark........see ignition service.If there is a spark... is there gas supplied to the unit and is theline purged of air?Does the other burner of a dual burner operate?Check the orifice for blockage.Check the burner inlet for obstructions.Check the air shutter for proper adjustment.Is the Side Burner in a dusty area? Move to less dusty area ifpossible.Is the fuel hose bent or kinked?Is there adequate gas supply available? If it is only oneburner of the dual burner unit that appears low, does theorifice or burner need cleaning?If using LP gas, check for empty tank.PROBLEM WHAT TO DOBefore replacing an ignition module, perform this simple test to check if the ignition module isworking or not. Remove the drip pan from under and behind the valve panel, look upward and locatewhere the electrode wire is connected.Disconnect the electrode wire and place the metal blade of a screw driver about an 1/8”from the metalterminal on the back of the ignition module. Engage the ignition button. You will see sparks jump tothe screw driver if the ignition module is good. If the ignition module is good, you should examine thewiring of the electrode for cracks or cuts. If there is no spark, remove and replace the ignition moduleand reassemble.