DCS CT-365BL Use And Care Manual

Also see for CT-365BK: Use and care manual Installation manual Use and care manual Installation manual Use and care guide

Contents

DCS CT-365BL Use And Care Manual Manual pdf 13 page image

Installation Instructions12PREPARING FOR THE INSTALLATION:Be sure to read page 11 for the proper ventilation requirements before you begin.When making your CUTOUT refer to page 13 on cabinet preparation.Step 1: Unpack the unit, the regulator, and remove all packing between all the burners, rings, andcaps. Remove the grates from their boxes.Step 2: With the necessary tools and hardware ready, measure the distance from the back andsides of the countertop and cabinet to locate the position of the cooktop Cutout.Step 3: Make your Cutout according to the dimensions given on page 13. Square the cutout tothe countertop.Step 4: Lower the cooktop into the countertop cutout, be careful not to damage the counter,inlet pipe threads, or the power cord of the cooktop.Step 5: Square the cooktop to the cutout and install the (4) retaining brackets onto the 8 holeslocated at the bottom of the unit, (See Figure 1 below).Step 6: Tighten the 4 preloaded screws which will keep the unit secured, Do Not Over-tighten(See Figure 2 detail below).Step 7: Install the regulator with the arrow in the direction of the gas flow ( towards thecooktop) using a sealant on the pipe threads. Put burner rings and burner caps in place.Step 8: Plug the unit into a wall outlet.Step 9: Connect the gas line to the unit. Refer to page 14 for gas supply hookup.Step 10: Turn ball valve to let the gas flow.Step 11: Turn knob on burner and apply a match to the burner until the gas lights being cautiousnot to burn your hand or other parts of your body.When the gas is first activated, thereis air present in the gas lines.The match applied to the burner makes it easier and safer toclear the air/gas mixture. Use Caution to avoid burn injury.Step 12: Put grates in place.FIG.1 FIG.2