DURKOPP ADLER 911 Operating & Installation Instructions Manual

Also see for 911: Operating & installation instructions Operating & installation instructions

9. Error messages/Information messages9.1 Error messagesError code Description RemedySewing motor1051 Sewing motor timeout- Faulty cable to the sewing motor referenceswitch- Faulty reference switch- Machine head rough-running or belt tension toohigh- Replace the cableReplace the reference switch- Check whether machine head isrough-runningand belt tension1052 Sewing motor excess current- Faulty sewing motor cable- Faulty sewing motor- Faulty control- Replace the sewing motor cable- Replace the sewing motor- Replace the control1053 Sewing motor mains voltage too high Check the mains voltage1055 Sewing motor overload- Sewing motor blocked/seized up- Faulty sewing motor- Control faulty- Eliminate blocking/seizing- Check the sewing motor- Check the control1056 Sewing motor overheat- Sewing motor seized up- Faulty sewing motor- Control faulty- Eliminate seizing- Replace sewing motor- Replace the control105813021342-1344Sewing motor speed- Faulty sewing motorFailure sewing motor IDMA AutoincrementControl receives no impulse from impulsetransmitter in the motorFaulty sewing motorInternal error- Replace the sewing motor- Check the cable from the impulsetransmitter in the motor to thecontrol- Switch the machine off and onagain- Software updateStepping motors2101 Stepping motor X-axis time out referencing- Setting reference switch faulty- Faulty cable to the reference switch- Faulty reference switch- Align the reference switch- Replace the cable- Check the reference switch2102 Stepping motor X-axis faulty current supply- Stepping motor blocked- Encoder cable disconnected/faulty- Encoder faulty- Remove the blocking- Check/replace the encoder cable- Replace the stepping motor2152 Stepping motor X-axis excess current - Replace the stepping motor- Replace the control2153 Stepping motor X-axis excess voltage- Mains voltage too highCheck the mains voltage2155 Stepping motor X-axis overload- Feeding system rough-running- Obstacles at feeding movements- Remove the blocking- Remove the obstacles/Adapt the movements591