CT-5322F/CT-5642F Fixed Thermal Analytic Camera QIG103.1. PreparationRead the instructions in this chapter thoroughly before installing the camera.Following are additional considerations for outdoor installation: Always use weatherproof equipment, such as boxes, receptacles,connectors, etc. For electrical wiring, use the properly rated sheathed cables forconditions to which the cable will be exposed (for example,moisture, heat, UV, physical requirements, etc.). Plan ahead to determine where to install infrastructureweatherproof equipment. Whenever possible, ground componentsto an outdoor ground. Use best security practices to design and maintain secured cameraaccess, communications infrastructure, tamper-proof outdoorboxes, etc. To minimize the effects of EMI (electromagnetic interference) and RFI(radio frequency interference), consult your reseller.3.2. Items Required for Installation That Are NotSuppliedThe following items are required for installation, but are not included in thepackage: Power source (PoE+ switch, 12-24VDC or 24VAC power supply) Shielded Twisted Pair (STP) cable if using a PoE+ switch Cat 5 Ethernet cable for network connection without a PoE+ switch Tripod or mounting bracket for mounting the camera One #2 Phillips head screwdriver One open-end, 1-inch (25.4mm) wrench or adjustable wrench One 6-inch (152mm) scale or ruler Electric or manual torque screwdriver set to 10 inch-pounds(1.23 Newton meters)