24 Installation (for qualified installers only)© Travis Industries 9/25/17-1468 MaestroConnecting the Intake Damper Harness to the FireplaceWARNING: DO NOT CONNECT THE INTAKE DAMPER WIRES TOGETHER(this will short the system). The 25’ intake damper harness is shipped in the hardware box (see page 8 for details). If additionallength is needed, use part 250-02295 (typically ordered when fireplace is configured) or 18 gaugewire. Route the intake damper harness through the cover plate and attach to the molex connector on thefireplace as shown below. The other end is attached to the damper(s).HINT: Keep the low voltage cover plate disconnected until all wiring to the fireplace is attached. Youmay also wish to leave the strain reliefs/clamps loose until the cover plate is ready to be attached.Intake DamperHarnessStrain Relief(remove to install wire)Use pliers to compress thestrain relief when insertingor removing it from the hole.1/4" NutdriverLow VoltageCover Plate
