26 Installation (for qualified installers only)© Travis Industries 9/25/17-1468 MaestroConnecting the Exhaust Damper Harness to the Fireplace This fireplace uses a damper near the power vent blower to prevent air from flowing through thefireplace when the fireplace is off. The exhaust damper harness is available in various lengths (see page 8 for details). Route the exhaust damper harness through the cover plate and attach to the molex connector on thefireplace as shown below.HINT: Keep the low voltage cover plate disconnected until all wiring to the fireplace is attached. Youmay also wish to leave the strain reliefs loose until the cover plate is ready to be attached. The opposite end of the damper harness attaches to the power vent assembly (see “Wiring the PowerVent” for details).Strain Relief(remove to install wire)Use pliers to compress thestrain relief when inserting orremoving it from the hole.ExhaustDamper Harness
