Dacor EO127 Use And Care Manual

Also see for Discovery EO Series: Installation instructions Use and care manual Installation instructions Use and care manual Use and care manual

Dacor EO127 Use And Care Manual Manual pdf 34 page image

324. Grasp the old bulb and pull it straight out of thesocket.5. using a glove, insert the new bulb into the socket.6. As you reinstall the lens cover, line up the cutout onthe inside rim with the light socket. Gently press itinto its original position.7. Turn the power to the oven back on at the main powersupply. reset the clock.Optional Baking Stone• Wash the optional baking stone with hot water andscrub it clean before you use it for the first time. Donot use any soap or detergents to wash the stone.The stone is porous and soap will get trapped inside.The trapped soap will affect the flavor of the foodcooked on it. Don’t be alarmed if the stone gets stainson it after it is used for a while. Stains do not affectthe stone’s ability to bake properly.• When you need to remove large food particles fromthe baking stone, use warm water and a scrub brush.If there is a lot of oil build-up, it may smoke andcreate odors. If you need to remove the oily build up,use a scouring pad or brush to remove it. You mayalso use a paste of baking soda and water to scrubsmall stained spots off.Optional Cookie Sheets• Clean aluminum cookie sheets with a solution ofdetergent and warm water. Since aluminum canscratch, you need to use the soft side of a sponge. Away for you to keep cookie sheets cleaner is to useparchment paper over the cooking surface duringbaking. The parchment paper will also prevent foodfrom sticking.warning• To prevent electrical shock and/or personal injury,make certain that the oven and light bulb(s) are cooland that power to the oven has been turned off atthe circuit breaker panel or fuse box before replacingthe light bulb(s).• Always ensure that the lens cover is in placewhen using the oven. The lens cover protects thebulbs from breakage that can be caused by hightemperatures or being bumped.• replacing the lens cover without lining up the cutoutwith the light socket will damage the light fixture.• Do not use a screwdriver to remove the lens.Light bulb replacement is considered a homeownermaintenance operation. If the lights do not work, beforereplacing them, please consult the Before You Call forService section.ImPortant: Do not touch the replacement halogen lightbulb with your fingers. Halogen bulbs are sensitive to theoils from your hand. The oils from your hand will stick tothe bulb and may cause it to burn out faster than normal.To Replace the Light Bulb(s):1. replace the bulb only with Dacor part No. 92317,available from any authorized Dacor parts dealer.2. Turn off power to the oven at the circuit breaker panelor fuse box.3. Hold your hand under the lens for support and gentlypry it loose using a spatula or table knife. pull the lenscover straight out.Care and CleaningReplacing the Light Bulbslight Bulb replacementLight bulbCutout: line up withlight socketLight socketLens