Dacor Epicure ER36GISCH Installation Instructions Manual

Also see for ER36G: Instructions Use and care manual Installation instructions

Contents

Dacor Epicure ER36GISCH Installation Instructions Manual Manual pdf 13 page image

11Installation InstructionsMoving the Range to Final LocationPeel the protective plastic coating off of the range,1)including the range door.Uncoil the power cord and route it to the electrical2)outlet so that it does not become trapped behindthe range when it is pushed back. Do not connectthe power plug until you are ready to verify properoperation.Carefully slide the range into position taking the slack3)out of the power cord as you push the unit into place.Be careful not to kink the power cord or gas line as youpush the unit back. The anti-tip foot should engage theanti-tip bracket as you slide it back.Re-Installing the DoorWARNINGTo avoid personal injury or damage to the door from itfalling off its hinges:Make sure that the notch on the bottom of each hinge•rests on top of the lower lip of each hinge receptaclebefore attempting to open the oven door.Rotate the hinge locks toward the front of the range•immediately after installation of the door.Grasp the oven door on opposite sides and hold it at a1)15° angle from the front of the oven. Slide the hingesinto the hinge openings, resting the bottom of the hingearms on the hinge receptacles.Continue to hold the door at a 15° angle with one hand2)while pushing in on each of the bottom corners of thedoor. Push until the notch on the bottom of each hingeslips over the lower lip of each hinge receptacle.Lower the door to the fully opened position.3)Rotate the two hinge catches toward the oven. Slowly4)and carefully open and close the door completely toensure that it is properly installed.Remove any packaging from inside the oven.5)Door InstallationLower lip of hingereceptacleNotch