Dacor Epicure ER36GISCH Installation Instructions Manual

Also see for ER36G: Instructions Use and care manual Installation instructions

Contents

Dacor Epicure ER36GISCH Installation Instructions Manual Manual pdf 8 page image

6Installation SpecificationsInstallation InstructionsVerifying the Package ContentsUnpack the range and verify that all required parts havebeen provided. If any item is missing or damaged, pleasecontact your dealer immediately. Do not install a damagedor incomplete appliance. The customer must reportcosmetic issues immediately to the dealer or builder.WARNINGObserve all governing codes and ordinances during•planning and installation. Contact your local buildingdepartment for further information.I• f the gas or electric service provided does not meetthe product specifications, do not proceed with theinstallation. Call the selling dealer, the gas supplier ora licensed electrician.This appliance must be installed by a licensed•plumber or gas fitter when installed within theCommonwealth of Massachusetts.Parts ListAnti-tip bracket•Grates (2) 12 inch, (1) 10 inch•Use and care manual•Stainless steel cleaner•Dual burner rings (2)•Outer dual burner caps (2)•Inner dual burner caps (2)•Standard burner caps (2) large, (2) small•Standard burner rings (2) large, (2) small•Oven racks (3)•The following parts are are included with model ER36GIonly. They are for use with self-rimming installations:3 Self-rimming trim pieces (left, right, rear)•2 Self-rimming side panels (left, right)•13 #8 x 1/4 Torx screws•See the use and care manual for a list of other optionalaccessories and parts.Gas and Electrical LocationsThe installation must allow for the following:•Access to the gas shut-off valve when the unit is◊installed.Access to the electrical outlet, when the range is in◊place.The gas supply piping, gas shut-off valve and the◊electrical junction box or receptacle must be locatedso they do not interfere with the range when it isinstalled.The electrical outlet and gas shut off valve must◊be located so that the range can be pulled out forservice while the appliance remains connected.Both the gas supply piping and shut-off valve and the•electrical outlet must be located so they do not interferewith the range when it is installed.Existing utility connections may be used for•replacement purposes, provided they meet local codeand fit within the utility clearance area at the back ofthe range (see diagram, right). Utility Clearance Behind RangeCLCL12 1/2” (318 mm)15” (381 mm)12” (305mm)2 1/2”(64mm)3 1/2”(89mm)1” (25mm)