12Installation InstructionsInstalling the Oven in the CabinetWARNING• Failure to properly install the mounting screws mayresult in movement or tipping of the oven during useresulting in personal injury.• Do not block the oven air exhaust located at the bot-tom of the oven. Blocking the intake may result in afire hazard, cabinet damage or poor performance.• The wall oven is heavy. Do not attempt to install it inthe cabinet with less than two people.• Do not use the exhaust grill or the bottom edge ofthe oven opening as a gripping point. Damage to theexhaust grill may result.1. Lift the wall oven up to the cabinet cut out, using theupper edge of the cavity opening and the bottom of theoven case side as gripping points. Be certain to take allnecessary safety precautions due to the weight of theappliance.2. Resting the oven on the cabinet-mounting platform,slide the oven into the recessed area until the rearedge of the oven frame is flush with the cabinet faceand the oven is centered within the cut out. Ensure thatthe electrical conduit slides through the opening in thecabinet platform or coils above the oven chassis as theoven is slid into place. The cable must be placed intothe recessed area located along the rear vertical edgeof the oven or coiled above the oven chassis. Do nottrap the appliance cable between the oven case backand the rear wall.3. Locate the mounting holes in the trim on both sidesof the oven. There are four (4) holes, two (2) on eachside, for single oven models and six (6) holes for dou-ble oven models.4. Use a 1/16” drill bit to drill pilot holes in the cabinetthrough all of the trim mounting holes.5. Install all of the provided #6 screws through the oventrim into the cabinet to secure the oven. Do not over-tighten the screws.Mounting Screws:Four (4) for single ovenSix (6) for double ovenGrippingpointGripping point:case bottomboth sidesDo notgrip here!