24 Chapter 6 : Adjusting the SoundC H A P T E R 6Adjusting the SoundSelecting stereo/SAPThe MTS(Multi-channel TV Sound) provides for an extra sound channel. So MTS featureallows you to improve your TV viewing with high fidelity stereo sound. SAP(Second AudioProgram) used to transmit a second language of other audio information. If your TV receives astereo sound(or SAP) broadcast, when the TV is turned on, select other channel or press theRECALL button on the remote control the word “Stereo”(or “SAP”) is displayed on the screen.Listening to stereo sound1 With the TV turned on, press the MENU button until “Sound” menu will be displayed.2 Use the VVCHWW buttons select “Audio Mode” item.3 Press the CVOLB buttons repeatedly until: “Stereo” is displayed.4 Press the button twice or wait few seconds to return to normal TV viewing.5 Your setting will remain intact until you change it. Your TV will then automatically repro-duce either stereo or monaural sound, whichever is broadcast.Listening to second Language1 Follow steps 1~2 in “Listening to stereo sound” above.2 Press the CVOLB buttons repeatedly until: “SAP” is displayed.3 Press the MENU button twice or wait few seconds to return to normal TV viewing.4 If a SAP broadcast is received, you will hear only the second language from the speaker.NoteIf a broadcast signal is weak, it may cause noise and hum in stereo sound. Please select theMono mode, the noise and hum should be reduced.