Daikin J-Series Engineeiring Data
Also see for FTKS09JEVJU: Service manualInstallation manualOperation manual
                                                                                                | |
Contents
| 
Installation Manual EDUS04101130 Room Air Conditioners J-Series73-2. Left-side, left-back, or left-bottom piping1) Attach the drain hose to the underside of the refrigerant pipeswith adhesive vinyl tape.2) Be sure to connect the drain hose to the drain port in place of adrain plug.3) Shape the refrigerant pipes along the pipepath marking on the mounting plate.4) Pass drain hose and refrigerant pipesthrough the wall hole, then set the indoorunit on mounting plate hooks, using themarkings at the top of indoor unit as aguide.5) Pull in the inter-unit wiring.6) Connect the inter-unit piping.7) Wrap the refrigerant pipes and drain hose together with insulation tape asright figure, in case of setting the drain hose through the back of the indoorunit.8) While exercising care so that the inter-unit wiring do not catch indoor unit,press the bottom edge of indoor unit with both hands until it is firmlycaught by the mounting plate hooks. Secure indoor unit to the mountingplate with indoor unit fixing screws 3/16 × 1/2 inch (M4 × 12mm).3-3. Wall embedded piping• Insert the drain hose to this depth so it won’t be pulled out of the drain pipe.• Replacing onto the left side1) Remove the insulation fixing screws on the rightto remove the drain hose.2) Reattach the insulation fixing screw on the rightas it was.* (Forgetting to attach this may cause waterleakages.)3) Remove the drain plug on the left side andattach it to the right side.4) Insert the drain hose and tighten with includedinsulation fixing screw.How to replace the drain plug and drain hoseDrain hose attachment position* The drain hose is on the back of the unit.Front side of unitAttachment on the right side (factory default)Attachment on the left sideDrain hose Drain hoseInsulationfixing screwInsulationfixing screwRight sideLeft sideRemove pipe port cover here for left-bottom piping.Remove pipeport coverhere for left-side piping.Left-bottom pipingLeft-sidepipingLeft-backpipingHow to set drain plug.No gap.Do not apply lubricatingoil (refrigeration oil)when inserting.Application of causesdeterioration and drainleakage of the plug.Insert a hexagonal wrench 3/16” (4mm).DrainhoseCaulk this holewith putty orcaulking material. Bind with vinyltape.A Mounting plateWrap insulating tape around thebent portion of refrigerant pipes.Overlap at least half the width ofthe tape with each turn.RefrigerantpipesDrain hoseBottom frameH Indoor unit fixing screw3/16” × 1/2” (M4 × 12mm)(2 point)MountingplateAInter-unit wiringInner wallVinyl chloridedrain pipe(VP-30)Drain hose1-15/16” (50mm)or moreInsert the drainhose to this depthso it won’t be pulledout of drain pipe.Outer wall |
Related manuals for Daikin FTKS09JEVJU
Daikin J-Series Engineeiring Data
Daikin H-Series Engineeiring Data
Daikin H-Series Engineering Data
Daikin VRV Series Engineering Data
Daikin FTX-N Series Engineering Data
Daikin FTV-A Series Engineering Data
Daikin FTXS-L Series Engineering Data
Daikin FTKS L Series Engineering Data
Daikin FXZQ-M Series Engineering Data
Daikin FTXR-T Series Engineering Data
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine