Dalsa Piranha HS Series User Manual

Also see for Piranha HS Series: User manual Getting started guide

Contents

Dalsa Piranha HS Series User Manual Manual pdf 113 page image

Piranha HS-xx RoHS User ManualTeledyne DALSA 03-032-20013-03113the analog offset u sing the cao or sao com m and s. Und er light cond itions, youshou ld receive a valu e.Verify VoltageUse the vv com m and to d isplay the cam era's inpu t voltage.Verify TemperatureTo check the internal tem peratu re of the cam era, u se the vt com m and . For properoperation, this valu e shou ld not exceed 75°C.Note: If the cam era reaches 75°C, the cam era w ill shutdow n and the LED w ill flash red.If this occu rs, the cam era must be rebooted u sing the com m and , rc or can be pow eredd ow n m anu ally. You w ill have to correct the tem peratu re problem or the cam era w illshu td ow n again. If you enter any com m and other than vt or rc, the cam era respond sw ith:Error 09: The camera's temperature exceeds the specified operatingrange>Verify Pixel CoefficientsUse the dpc com m and to d isplay the pixel coefficients in the ord er FPN , PRN U, FPN ,PRN U… The cam era also retu rns the pixel nu m ber for each fifth pixel.End-of-line SequenceTo fu rther aid d ebu gging, the cam era can generate an end -of-line sequ ence. The end -of-line-sequ ence ou tpu ts "aa", "55", "line cou nter", "line average", "pixels above threshold ","pixels below threshold ". To activate the end -of-line sequ ence, u se the com m and els 1.To d isable the end -of-line sequ ence, u se the com m and els 0.Use the sut and slt com m and s to set threshold valu es betw een 0 and 255 for 8 bit d atam od es, or 0 to 4096 for 12 bit d ata m od es.Specific SolutionsNo Output or Erratic BehaviorIf you r cam era provid es no ou tpu t or behaves erratically, it m ay be picking u p rand omnoise from long cables acting as antennae. Do not attach w ires to u nu sed pins. Verify thatthe cam era is not receiving spu riou s inpu ts (e.g. EXSYN C if cam era is in exposu re m od ethat requ ires external signals). Unu sed signals in the Cam era Link cable shou ld beterm intated in 100Ω.All manuals and user guides at all-guides.com