Dalsa Stop Action 4M30 User Manual

Contents

Dalsa Stop Action 4M30 User Manual Manual pdf 12 page image

PRELIMINARY 4M Stop Action Camera Manual03-32-10121-09 DALSA12fer to section 2.2.3 Power Connector forFigure 6: Input and Output• One 6-pin Hirose connector for power. Redetails.Camera Link (Base Configuration)Camera Link (Medium Configuration)Diagnostic LED+12V to +15VCONTROLDATA 1DATA 2POWERWARNING: Ensure that allpower (irrespective of cablthe correct voltages at full load are present at the camera end of thee length) according to the pinout defined in section 2.2.3 Power.2.ith a red/green LED used to display the operational status ofra. The table below summarizes the operating states of the camera and thecorresponding LED states.ore tha dition with the highesty. Error ing messages furtherhe currentTable 3: Status LEDConnector.1 LED Status IndicatorThe camera is equipped w2the cLED indicateameWhen m n one condition is active, the s the conpriorit and warning states are accompanied by corresponddescribing t camera status.Flashing Green Camera initialization or executing a time consuming commandSolid Green Camera is operational and functioning correctlyFlashing Red Fatal Error. System voltage out of tolerance.Solid Red Warning. Loss of functionality (e.g. external SRAM failure)2.2.2 Camera Link Data ConnectorFigure 7: Camera Link MDR26 ConnectorMDR26 Female1141326M at ing Par t: 3M 334-31 ser iesC able: 3M 14X 26-SZ LB-X X X -0LC* *The Camera Link interface is implemented as either a Base or Medium Configuration inthe stop action 4M cameras. You select the camera configuration with the clm commanddescribed in section 3.3.2 Setting the Camera Link Mode .