Xtium-CL MX4 User's Manual Technical Specifications • 93J3: Camera Link Connector 1Name Pin # Type DescriptionBASE_X0- 25 Input Neg. Base Data 0BASE_X0+ 12 Input Pos. Base Data 0BASE_X1- 24 Input Neg. Base Data 1BASE_X1+ 11 Input Pos. Base Data 1BASE_X2- 23 Input Neg. Base Data 2BASE_X2+ 10 Input Pos. Base Data 2BASE_X3- 21 Input Neg. Base Data 3BASE_X3+ 8 Input Pos. Base Data 3BASE_XCLK- 22 Input Neg. Base ClockBASE_XCLK+ 9 Input Pos. Base ClockSERTC+ 20 Output Pos. Serial Data to CameraSERTC- 7 Output Neg. Serial Data to CameraSERTFG- 19 Input Neg. Serial Data to Frame GrabberSERTFG+ 6 Input Pos. Serial Data to Frame GrabberCC1- 18 Output Neg. Camera Control 1CC1+ 5 Output Pos. Camera Control 1CC2+ 17 Output Pos. Camera Control 2CC2- 4 Output Neg. Camera Control 2CC3- 16 Output Neg. Camera Control 3CC3+ 3 Output Pos. Camera Control 3CC4+ 15 Output Pos. Camera Control 4CC4- 2 Output Neg. Camera Control 4PoCL 1,26 +12 V (see note following table)GND 13, 14 GroundNotes on PoCL support: Refer to Sapera’s parameter CORACQ_PRM_POCL_ENABLE to enable PoCL andCORACQ_PRM_SIGNAL_STATUS/CORACQ_VAL_SIGNAL_POCL_ACTIVE to verify if the POCL isactive. See also Sapera++ reference parameter SapAcquisition::SignalPoCLActive for thecurrent state. PoCL state is maintained as long as the board is not reset
