96 • Technical Specifications Xtium-CL MX4 User's ManualJ1: External Signals Connector (Female DH60-27P)Warning: J1 and J4 have the same pinout assignment. Signals are routed to both connectorsdirectly from their internal circuitry. Therefore never connect both J1 and J4 to externaldevices at the same time.See DH40-27S Cable to Blunt End (OR-YXCC-27BE2M1, Rev B1) and Cable assemblies for I/Oconnector J4 for available cables.J4: Internal I/O Signals Connector (26-pin SHF-113-01-L-D-RA)Important: The table below describes the I/O signals available on both J1 and J4.(applies to Xtium-CL MX4 rev. A2)Use only one of the two I/O connectors — never both!Xtium-CL MX4 rev. A2Description Pin # Pin # DescriptionGround 1 15 General Input 3 (+)RS-422 Shaft Encoder Phase A (-) 2 16 General Input 4 (+)RS-422 Shaft Encoder Phase A (+)(see note 3)3 17 General Input 4 (-)Ground 4 18 General Input 3 (-)RS-422 Shaft Encoder Phase B (-) 5 19 Power Output 5 Volts, 100mA maxRS-422 Shaft Encoder Phase B (+) 6 20 External Trigger Input 2 orGeneral Input 2 (-)External Trigger Input 1/General Input 1 (-) 7 21 General Output 3External Trigger Input 1/General Input 1 (+) 8 22 General Output 4External Trigger Input 2/General Input 2 (+) 9 23 General Output 5Ground 10 24 General Output 6Strobe 1 / General Output 1(See note 2)11 25 General Output 7Strobe 2 / General Output 2(See note 2)12 26 General Output 8Ground 13 27 NCPower Output 12 Volts, 350mA max(from Aux Power Connector, see J7)14Important: The table below describes the I/O signals available on both J1 and J4.(applies to Xtium-CL MX4 rev. A1)Use only one of the two I/O connectors — never both!
