Danfoss DLX 2.0 Installation Manual

Danfoss DLX 2.0 Installation Manual Manual pdf 38 page image

38 Installation Guide DLX series L00410622-014. Connection between Inverter and PCThe site performance can be checked remotely by using a computer. The connection canbe achieved between the inverter and the computer either directly or via a network.4.1. Without a NetworkTo connect the inverter and the computer directly a regular Ethernet cable is needed. If thenetwork card in the computer does not support Autosense, a crossover cable is needed tocreate a connection to the inverter.Figure 4.1.1:Connection without network1. Follower inverter2. Master inverter3. CAN bus cable4. Ethernet cable5. RS-485 cable6. Computer7. Data loggerNOTICEWith several inverters connected together via CAN bus the Ethernet cable must beattached to the master inverter only.4.1.1. IP AddressThe computer’s and the inverter’s IP address must be in the same range. If the inverter’s IPaddress is 192.168.10.X, the computer’s IP address must be 192.168.10.Y, where X and Y aredifferent numbers between 1 and 254.InverterThe inverter’s default IP address is 192.168.10.20. To change the IP address, go toSetup>Network Setup and set the inverter’s IP address as required.To connect the PC and the inverter, the inverter’s IP address must be entered into the PCweb browser address line.Refer to User Guide for more detailed information about Network setup