Danfoss DLX 2.0 Installation Manual

Danfoss DLX 2.0 Installation Manual Manual pdf 6 page image

6 Installation Guide DLX series L00410622-011.3.2. Unpacking• Place the box in position, with the top clearly visible and according to the arrow markingon the packaging.• Cut the seal, and open the box.• Take out the lock clip, the bag with accessories and the Installation Guide lying on theupper section of the foam packaging material.• Remove the upper part of the foam packaging material.• Both sides of the inverter case are narrowed in order to get abetter grip on the device. Lift up the inverter carefully out ofthe box using the “handles” illustrated in Figure 1.3.2.• Remove the lower section of the foam packaging and takeout the inverter mounting bracket.• Store all the original packaging for possible later reuse.Figure 1.3.2: “Handles”After unpacking the inverter safely, check that all components are present and in anundamaged condition.1.3.3. Scope of Delivery• DLX single phase inverter• Mounting bracket• Installation Guide• Accessories: grounding strap, bracket screws, lock clip, extra type labelNOTICEThe mating parts of the connectors are not part of the standard scope of supply,and must be provided by the system installer.1.3.4. Inverter StructureThe housing of the DLX series inverter is designed for indoor and outdoor use (IP65), andprovides a degree of protection from dirt, rain, sleet, snow, dust, water, and corrosion.Figure 1.3.3: Mechanical dimensionsH: 610 mmW: 353 mmD: 158 mm