Danfoss MCO 305 Operating Instructions Manual

Also see for MCO 305: Operating instructions Design guide Design guide

MCO 305 Operating Instructions__ Appendix __¾default setting [ ] value for use in communication via serial communication port48 MG.33.K2.02 – VLT is a registered Danfoss trademark Application Parameters, Parameter ListPar. No. # Parameter name Parameter description DefaultsettingChanges duringoperation4-set-up Conver-sionindexType19-0* Application Parameters19-00 Application parameters 0 TRUE… TRUE19-89 Application parameters 0 TRUE19-9* Read-only Application Parameters19-90 Application parameter 90 0 read only 1 set-up 0 Int3219-91 Application parameter 91 0 read only 1 set-up 0 Int3219-92 Application parameter 92 0 read only 1 set-up 0 Int3219-93 Application parameter 93 0 read only 1 set-up 0 Int3219-94 Application parameter 94 0 read only 1 set-up 0 Int3219-95 Application parameter 95 0 read only 1 set-up 0 Int3219-96 Application parameter 96 0 read only 1 set-up 0 Int3219-97 Application parameter 97 0 read only 1 set-up 0 Int3219-98 Application parameter 98 0 read only 1 set-up 0 Int3219-99 Application parameter 99 0 read only 1 set-up 0 Int32 MCO Basics Settings, Parameter ListPar. No.#Parameter name Parameter description DefaultsettingChangesduringoperation4-set-up Conver-sionindexType32-0* Encoder 2 - Slave32-00 ENCODERTYPE Incremental Signal Type [1] RS422 TRUE 1 set-up Uint832-01 ENCODER Incremental Resolution 1024 PPR TRUE 1-set-up Uint3232-02 ENCODER ABSTYPE Absolute Protocol [0] None TRUE 1-set-up Uint832-03 ENCODER ABSRES Absolute Resolution 8192 PPR TRUE 1-set-up Uint3232-05 ENCODER ABSTYPE Abs. Encoder Data Length 25 Bit TRUE 1-set-up Uint832-06 ENCODERFREQ Absolute Encoder ClockFrequency262.000 kHz TRUE 1-set-up Uint3232-07 ENCODER CLOCK Absolute Encoder ClockGeneration[1] On TRUE 1-set-up Uint832-08 ENCODER DELAY Absolute Encoder CableLength0 TRUE 1-set-up Uint1632-09 ENCODERMONITORINGEncoder Monitoring [0] Off TRUE 1-set-up Uint832-10 POSDRCT Rotational Direction [1] No action TRUE 1-set-up Uint832-11 POSFACT_N User Unit Denominator 1 TRUE 1-set-up Uint3232-12 POSFACT_Z User Unit Numerator 1 TRUE 1-set-up Uint32