Danfoss TP9 User Instructions

Also see for TP9: Installation instructions

Contents

For 24 hour mode

Danfoss TP9 User Instructions Manual pdf 2 page image

Danfoss Randall LtdAmpthill RoadBedford, MK42 9ERTel: 01234 364621Fax: 01234 219705Email: danfossrandall@danfoss.comWebsite: www.danfoss-randall.co.ukFig.15Fig.12Fig.13Fig.11For 24 hour mode (same set of programmes for each day of the week)a) Press PROG (Fig 2) 3 times to show the 1st pre-set time and temperature(Event 1) (Fig.11)b) Use + or – buttons (Fig.3) to adjust the TIME (press and hold to change in10 min increments)c) Use or buttons (Fig.8) to adjust the TEMPERATUREd) Press PROG (Fig.2) to move to next preset time & temperature (Event 2)e) Repeat steps b, c & d for programming Events 3, 4 5 & 6Programming your HOT WATERTo set the hot water programme press the PROG button (Fig.2) until Event A (1stON) appears on the display (Fig.13).b) Use + or – buttons (Fig.3) to adjust the TIME (press and hold to change in 10minute increments)c) Use or buttons (Fig.8) to adjust the TEMPERATUREd) Press PROG (Fig.2) to move to Event b - 1st OFFe) Repeat steps b, c & d for programming Events C & d (2nd ON & 2nd OFF)NB. Right hand LED will be lit when the Water programme is runningReturning to RUN modePress PROG until the colon in the LCD display starts to flash (Fig.14)Temporary User OverridesThe TP9 has several useful overrides which can be selected without affectingthe thermostat programming• Temporary override of programmed temperature – press or (Fig.8)until required temperature is displayed (override will automatically cancel atbeginning of next programmed event)• +1HR = if pressed while the programme is on, the hot water will remain onfor an extra hour. If it is pressed whilst the programme is off, the hot waterwill come on immediately for 1 hour then go off (Fig.15)• Frost Protection – a constant low temperature can be selected whilst awayfrom home - press & together (Fig.16) until display resembles (Fig.17)• Hot Water only (during summer) - press & together (Fig.16) untildisplay resembles (Fig.18)Summer Time / Winter Time Clock• To change from Summer to Winter (clocks back) - press and hold - (Fig.19)• To change from Winter to Summer (clocks forward) - press and hold + (Fig.19)Low BatteryIf the unit is disconnected from the mains supply a low battery symbol will flashin the LCD display (Fig.20). Programmes will be retained for 15 days. On the16th day of continuous disconnection the display will show just a colon. Whenpowere is eventually restored your programmes will be remebered - you willonly need to reset the time and the day of the week.Domestic Hot Water TimesSetting Function Pre-setA On 6:30AMb Off 8:30AMC On 5:30PMd Off 10:30PMFig.14Fig.17Fig.18Fig.19Fig.20Clocks back(Autumn)Clocks forward(Spring)Fig.16

/ 2

Related manuals for Danfoss TP9