Danfoss VLT 8000 AQUA series Operating Instructions Manual

Also see for VLT 8000 AQUA series: Instruction manual Operating instructions

Contents

Danfoss VLT 8000 AQUA series Operating Instructions Manual Manual pdf 84 page image

VLT ® 8000 AQUA■ Control unit LCPThe front of the frequency converter featuresa control panel - LCP (Local Control Panel).This is a complete interface for operation andprogramming of the VLT 8000 AQUA.The control panel is detachable and can - as analternative - be installed up to 3m/10 ft away fromthe frequency converter, e.g. on the front panel,by means of a mounting kit option.The functions of the control panel can bedivided into five groups:1. Display2. Keys for changing display mode3. Keys for changing program parameters4. Indicator lamps5. Keys for local operation.All data are indicated by means of a 4-linealpha-numeric display, which, in normal operation,is able to show 4 operating data values and 3operating condition values continuously. Duringprogramming, all the information required for quick,effective parameter Setup of the frequency converterwill be displayed. As a supplement to the display,there are three indicator lamps for voltage (ON),warning (WARNING) and alarm (ALARM), respectively.All frequency converter parameter Setups can bechanged immediately via the control panel, unless thisfunction has been programmed to be Locked [1] viaparameter 016 Lock for data change or via a digitalinput, parameters 300-307 Lock for data change.■ Control keys for parameter setupThe control keys are divided into functions. This meansthat the keys between display and indicator lampsare used for parameter Setup, including selecting thedisplay indication during normal operation.[DISPLAY MODE] is used for selectingthe indication mode of the display orwhen returning to the Display modefrom either the Quick menu or theExtend menu mode.[QUICK MENU] gives access to theparameters used for the Quick menu.It is possible to switch between theQuick menu and the Extend menumodes.[EXTEND MENU] gives access to allparameters. It is possible to switchbetween the Extend menu and theQuick menu modes.[CHANGE DATA] is used for changinga setting selected either in the Extendmenu or the Quick menu mode.[CANCEL] is used if a change ofthe selec-ted parameter is not to becarried out.[OK] is used for confirming a changeof the parameter selected.MG.83.A2.02 - VLT is a registered Danfoss trademark84