Danfoss VLT AutomationDrive FC 301 Programming Manual

Also see for VLT AutomationDrive FC 301: Programming guide Installation guide Operating guide Installation guide Design guide

Contents

Danfoss VLT AutomationDrive FC 301 Programming Manual Manual pdf 187 page image

3.19 Parameters: 18-** Data Readouts 218-36 Analog Input X48/2 [mA]Range: Function:0* [-20 - 20] View the actual current measured at input X48/2.18-37 Temp. Input X48/4Range: Function:0* [-500 -500]View the actual temperature measured at inputX48/4. The temperature unit is based on theselection in parameter 35-00 Term. X48/4Temperature Unit.18-38 Temp. Input X48/7Range: Function:0* [-500 -500]View the actual temperature measured at inputX48/7. The temperature unit is based on theselection in parameter 35-02 Term. X48/7Temperature Unit.18-39 Temp. Input X48/10Range: Function:0* [-500 -500]View the actual temperature measured at inputX48/10. The temperature unit is based on theselection in parameter 35-04 Term. X48/10Temperature Unit.3.19.1 18-4* PGIO Data ReadoutsParameters for configuring the readout of VLT®Programmable I/O MCB 115.18-43 Analog Out X49/7Shows the actual value at output of terminal X49/7 in V or mA.The value reflects the selection in parameter 36-40 Terminal X49/7Analogue Output.Range: Function:0* [0 - 30]18-44 Analog Out X49/9Shows the actual value at output of terminal X49/9 in V or mA.The value reflects the selection in parameter 36-50 Terminal X49/9Analogue Output.Range: Function:0* [0 - 30]18-45 Analog Out X49/11Shows the actual value at output of terminal X49/11 in V or mA.The value reflects the selection in parameter 36-60 TerminalX49/11 Analogue Output.Range: Function:0* [0 - 30]3.19.2 18-5* Active Alarms/WarningsThe parameters in this group show the numbers ofcurrently active alarms or warnings.18-55 Active Alarm NumbersThis parameter contains an array of up to 20 alarms that arecurrently active. The value 0 means no alarm.Range: Function:0* [0 - 65535]18-56 Active Warning NumbersThis parameter contains an array of up to 20 warnings that arecurrently active. The value 0 means no warning.Range: Function:0* [0 - 65535]18-60 Digital Input 2Range: Function:0* [0 - 65535] View the signal states from the active digitalinputs. 0 = no signal, 1 = connected signal.18-90 Process PID ErrorRange: Function:0 %* [-200 - 200 %] Gives the present error value used by theprocess PID controller.18-91 Process PID OutputRange: Function:0 %* [-200 - 200 %] Gives the present raw output value fromthe process PID controller.18-92 Process PID Clamped OutputRange: Function:0 %* [-200 - 200 %] Gives the present output value from theprocess PID controller after the clamplimits have been observed.18-93 Process PID Gain Scaled OutputRange: Function:0 %* [-200 -200 %]Gives the present output value from theprocess PID controller after the clamplimits have been observed and theresulting value has been gain scaled.Parameter Descriptions Programming GuideMG33ML02 Danfoss A/S © 02/2016 All rights reserved. 1853 3