Danfoss VLT DriveMotor FCP 106 Design Manual

Also see for VLT DriveMotor FCM 106: Operating instructions Operating instructions Design guide Programming guide Installation instructions

Contents

Danfoss VLT DriveMotor FCP 106 Design Manual Manual pdf 70 page image

Minimum ambient temperature during full-scale operation -10 °C (14 °F)Minimum ambient temperature at reduced performance -20 °C (-4 °F)Maximum ambient temperature at reduced performance 50 °C (122 °F)Temperature during storage -25 to +65 °C (-13 to +149 °F)Temperature during transport -25 to +70 °C (-13 to +158 °F)Maximum altitude above sea level without derating 1000 m (3280 ft)Maximum altitude above sea level with derating 3000 m (9842 ft)Safety standards EN/IEC 60204-1, EN/IEC 61800-5-1, UL 508CEMC standards, emission EN 61000-3-2, EN 61000-3-12, EN 55011, EN 61000-6-4EMC standards, immunity EN 61800-3, EN 61000-6-1/2Energy efficiency class, VLT® DriveMotor FCP 1062) IE2Energy efficiency class, VLT® DriveMotor FCM 106 IES1) The stated IP and Type rating only apply when the FCP 106 is mounted on a wall mount plate or a motor with the adapterplate. Ensure that the gasket between the adapter plate and the motor has a protection rating corresponding to the requiredrating for the combined motor and frequency converter. As standalone frequency converter, the enclosure rating is IP00 andOpen type.2) Determined according to EN50598-2 at:• Rated load.• 90% rated frequency.• Switching frequency factory setting.• Switching pattern factory setting.6.6 Cable SpecificationsCable lengths and cross-sectionsMaximum motor cable length for wall mount kit, screened/armored 2 m (6.56 ft)Maximum cross-section to motor, mains for MH1–MH3 4 mm2/11 AWGMaximum cross-section DC terminals on enclosure type MH1–MH3 4 mm2/11 AWGMaximum cross-section to control terminals, rigid wire 2.5 mm2/13 AWGMaximum cross-section to control terminals, flexible cable 2.5 mm2/13 AWGMinimum cross-section to control terminals 0.05 mm2/30 AWGMaximum cross-section to thermistor input (at motor connector) 4 mm2/11 AWG6.7 Control Input/Output and Control DataDigital inputsProgrammable digital inputs 4Terminal number 18, 19, 27, 29Logic PNP or NPNVoltage level 0–24 V DCVoltage level, logic 0 PNP <5 V DCVoltage level, logic 1 PNP >10 V DCVoltage level, logic 0 NPN >19 V DCVoltage level, logic 1 NPN <14 V DCMaximum voltage on input 28 V DCInput resistance, Ri Approximately 4 kΩDigital input 29 as pulse input Maximum frequency 32 kHz push-pull-driven and 5 kHz (O.C.)Analog inputsNumber of analog inputs 2Terminal number 53, 54Terminal 53 mode Parameter 6-19 Terminal 53 mode: 1=voltage, 0=currentTerminal 54 mode Parameter 6-29 Terminal 54 mode: 1=voltage, 0=currentVoltage level 0–10 VInput resistance, Ri Approximately 10 kΩSpecifications VLT® DriveMotor FCP 106/FCM 10668 Danfoss A/S © 06/2016 All rights reserved. MG03M20266