Danfoss VLT FC 100 LonWorks Manual

Also see for FC 100 Series: Operating instructions Instruction manual Manual Manual Programming guide

Danfoss VLT FC 100 LonWorks Manual Manual pdf 49 page image

8 Parameters8.1 Parameter list8.1.1 Parameter listPar. No. Parameter name: Default value: Range: Conversiontype: Data type:8-01 Control Site Dig. and control word [0] [0 - 2] - 58-02 Control Word Source FC Port [1] [0 - 4] - 58-03 Control Word Timeout Time 600 s 0.1 - 18000 1 78-04 Control Word Timeout Function Off [0] [0 - 10] - 58-05 End-of-timeout Function Hold set-up [0] [0 - 1] - 58-06 Reset Control Word Timeout Do not reset [0] [0 - 1] - 58-07 Diagnosis Trigger Disable [0] [0 - 3] - 58-10 Control Word Profile FC profile [0] [0 - x] - 58-50 Coasting Select Logic OR [3] [0 - 3] - 58-52 DC Brake Select Logic OR [3] [0 - 3] - 58-53 Start Select Logic OR [3] [0 - 3] - 58-54 Reversing Select Logic OR [3] [0 - 3] - 58-55 Set-up Select Logic OR [3] [0 - 3] - 58-56 Preset Reference Select Logic OR [3] [0 - 3] - 511-00 Neuron ID 00 00 00 00 00 00 - - 1011-10 Drive Profile VSD 6010 [0] - - 511-15 Lon Warning Word 0 - - 611-18 LonWorks Revision [0, 10] - - 911-21 Store Data Values Off [0] [0 - 1] - 58.2 Parameter Group 8-**8-01 Control SiteOption: Function:The setting in this parameter overrides the settings in par.8-50Coasting Select to par.8-56PresetReference Select.[0] * Digital and ctrl.word Control by using both digital input and control word.[1] Digital only Control by using digital inputs only.[2] Controlword only Control by using control word only.8-02 Control SourceOption: Function:Select the source of the control word: one of two serial interfaces or four installed options. Duringinitial power-up, the frequency converter automatically sets this parameter toOption A [3] if itdetects a valid fieldbus option installed in slot A. If the option is removed, the frequency converterdetects a change in the configuration, sets par. 8-02Control Source back to default settingFCPort, and the frequency converter then trips. If an option is installed after initial power-up, thesetting of par. 8-02Control Source will not change but the frequency converter will trip and display:Alarm 67Option Changed.[2] FC USB[1] Drive Port[0] None[1] FC PortVLT® FC 100 LonWorks 8 ParametersMG.11.E2.02 - VLT® is a registered Danfoss trademark 498