Data Controls GS-2328KX Installation And Getting Started Manual
                                               | |
Contents
| 
Publication date: Feb., 2012Revision A14DESCRIPTION OFHARDWARE1000BASE-TPORTSThe switch contains 24 1000BASE-T RJ-45 ports. All RJ-45 portssupport automatic MDI/MDI-X operation, auto-negotiation andIEEE 802.3x auto-negotiation of flow control, so the optimumdata rate and transmission can be selected automatically.SFPTRANSCEIVERSLOTSGS-2328KX supports the Small Form Factor Pluggable (SFP)transceiver slots are shared with RJ-45 port 21 to 24. In thedefault configuration, if an SFP transceiver (purchasedseparately) is installed in a slot and has a valid link on the port,the associated RJ-45 port is disabled.The following table shows a list of transceiver types which havebeen tested with the switch. For an updated list of vendorssupplying these transceivers, contact your local dealer. Forinformation on the recommended standards for fiber opticcabling, see “1000 Mbps Gigabit Ethernet Collision Domain” onpage 28.Table 1: Supported SFP TransceiversMedia Standard Fiber Diameter(microns)Wavelength (nm) Maximum Distance*1000BASE-SX 50/12562.5/125850850550 m275 m1000BASE-LX/LHX/ XD/ZX9/1259/1251310155010,30 km30,50 km1000BASE-LXSingle Fiber9/125 TX-1310/RX-1550Tx-1550/RX-131010,20 km10,20 km1000BASE-T N/A N/A 100 m100-FX 62.5/1259/125131013102 km20,40,60 kmN OTE: * Maximum distance may vary for different SFP vendors |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine