78 Printer ManagerFrontPanelUse the FrontPanel settings to customize the printer front panel.Change the front panel settings as needed, and then click Set Current to apply the changes. BacklightBrightness—Set the LCD front panel backlight brightness at the desired level, from0 percent (no backlight) to 100 percent (bright). KeySenseLevel—Set the front panel key sensitivity to a comfortable level. Select from 0 (lowsensitivity, almost a press) to 10 (high sensitivity, barely a touch). LcdConfigMenu—Enable or disable access to the Configuration menu on the LCD panel menusystem. (The Status and Maintenance menus cannot be disabled.) LedCardsPickedToCleaning—Set the number of cards to pick between required cleaning. Thecard light blinks amber when the printer reaches this value. If this value is set to 0, cardsbetween cleaning are not tracked. We recommend that you clean the printer after every 500cards to maintain print quality. LedPrintheadCyclesToCleaning—Set the number of printhead cycles between requiredcleaning. The card light blinks amber when the printer reaches this value. If this value is setto 0, cycles between cleaning are not tracked. LedRibbonLow—Set the percentage of ribbon remaining before being notified that theribbon is low and should be changed. The ribbon light blinks amber when the ribbon reachesthis value. SpeakerEnabled—Enable or disable the external printer speaker. The speaker provides asound in addition to the front panel lights and LCD text.DescriptionDefaultValueCurrent Value(unit)AllowedRange1) BacklightBrightness 100 100 [0 – 100]2) KeySenseLevel 5 5 [0 – 10]3) LcdConfigMenu Enabled Enabled4) LedCardsPickedToCleaning 500 500 [0 – 1000000]5) LedPrintheadCyclesToCleaning 2500 2500 [0 – 1000000]6) LedRibbonLow 10 10 [0 – 1000000]7) SpeakerEnabled Enabled Enabled
