Page 95OP-01615, OP1665 L1 or L2 Supply OutOut of supply material in the laminator.Possible Cause 1: The supply roll is empty.Solution 1: Replace the supply material, following the diagram in thecartridge.Possible Cause 2: The laminator cartridge is empty or removed becauseyou do not want to apply material to the card. However, PrintingPreferences, Properties, or Document Defaults is set to apply material fromthis laminator.Solution 2: Change the Apply Material setting to “Do not apply.” to preventuse of this laminator.Possible Cause 3: You have installed a defective roll of laminator supplymaterial.Solution 3: Install another roll of laminator supply material.If your printer has two laminators:• Make sure you load the correct material for the laminator. Message OP-01615 applies to the L1 laminator and message OP-01665 applies to the
