Page 402 Press the Enter key to display the current value.3 Press the Up or Down Arrow key to change the backlighting. The display changesto show the effect of the new value.4 When the backlighting reaches the level you want, press the Enter key. Thedisplay remains at the new backlighting level and you return to the Configurationmenu.5 Press the Up or Down Arrow key if needed to scroll to “Exit” on line 2.6 To print cards, press the Enter key repeatedly to return to the “Printer Ready”display.Set the Address ModeTips for success• When you choose an address mode, you determine how the network address of the printer is assigned. Usethe address mode requested by your network personnel. The possible values are DHCP and Static IP. DHCPstands for “Dynamic Host Configuration Protocol.” If the network supports DHCP, the network assigns the IPaddress (and other values) to the printer. Static IP means that the IP address is entered following theprocedure in "Set the IP Address, Subnet Mask, and Gateway Address" on page 42.• If you have the Smart Driver installed and connected to the printer from any PC, suspend communicationusing the Printer Toolbox. If you change IP addresses, communication with the printer can end unexpectedly.
