Datacolor CONDITIONER™ (MB2) 06/2017 page 28/126(3) Hose connectionsPlug the freshwater hose into the hose connection (9) above the freshwater can and secure it witha hose clamp. You can use a part of the standard supplied water hose.Screw the hose nozzle (brass) to the free edge of the hose and screw it directly onto the freshwa-ter connection “IN” (6) at the rear of the cabinet.When the freshwater can is empty, the message “Freshwater supply” will be displayed on the controller(chap. 11.1.3), the buzzer sounds, and the humidification module turns off. After acknowledging thealarm, the humidification module tries to fill up and start operating.To guarantee humidification during 24 hours even at high humidity set-points with manualwater supply, we recommend filling the freshwater can (option) at the end of each day.4.5.2 Mounting the wastewater can(1) Fixing (if required)Hang the can with its holding device on its 4 carriers at the free space next to the freshwater can.(2) Hose connectionsPlug the wastewater hose to the hose connection (10) of the wastewater can and secure it with ahose clamp. You can use a part of the standard supplied water hose.Hose connection of the wastewater can (10)Figure 13: Wastewater can (option)Plug the free hose edge to the wastewater connection “OUT” (7) at the rear of the cabinet and se-cure it with a hose clamp.You can remove the wastewater can with its holding device for emptying (disconnect the hose first beforeemptying).CAUTIONOverflow of the wastewater can.Damage to the surrounding. Empty the wastewater can in a timely manner before it is full.Bringing a source of humidity into the inner chamber may increase wastewater production.Regularly check the filling level of the wastewater can.
