Datacolor CONDITIONER™ (MB2) 06/2017 page 74/12611.1.2 Alarm messagesCondition Alarm message Start aftercondition occurredZero-voltage relayalarm output (option)The current actual temperature valueis outside the tolerance range (chap.11.4)“Temperature range after configurabletime time as alarm startThe current actual humidity value isoutside the tolerance range (chap.11.4)“Humidity range after configurabletime time as alarm startCabinet door open “Door open after 5 minutes ----Power failure --- ---- immediatelyExceeded setpoint of the safety control-ler class 3.1 “Safety controller immediately ----Temperature sensor defective e.g. “- - - - “ or“<-<-< “ or “>->->” immediately ----Safety controller temperature sensordefectiveSafety controllersensor immediately ----Alarm messages are displayed in the list of active alarms until acknowledging them. They are also shownin the event list.11.1.3 Messages concerning the humidity systemCondition and measures Message Start after conditionoccurredThe humidity module is defective. Contact your localDatacolor service representative. “Humidity system” immediatelyThe humidity module cannot fill up.In case of freshwater supply via water pipe:The water tap is closed, or the cabinet is defective (e.g.inlet valve of humidity module).In case of freshwater supply via freshwater can (option,chap. 4.5):Water can is empty. Humidification is turned off. In caseof refrigerating operation, the interior is strongly dehu-midified. When the water supply is functional again, thehumidity system restarts, or the cabinet is defective.“Freshwater supply” immediatelyThe humidity module cannot empty the condensatetank.Wastewater tube obstructed. Check the length and loca-tion of the wastewater tube. If appropriate contact yourlocal Datacolor service representative.“Waste water” immediatelyPurging is required soon. Turn off and on again thehumidity switch to start purging. After a successful purg-ing the notification resets automatically.“Humidity systempurging req.”after predefined time(approx. 3-5 monthsdepending on use)Maintenance of the humidity system is required. Contactyour local Datacolor service representative.“Humidity moduleservice”after predefined time(approx. 1 year)Messages concerning the humidity system are shown in the event list.
