REFERENCES 5In batch mode, the selected Transmission Mode determines the behavior of the gunat the time the list of codes is transmitted. If One-way mode is enabled, the codes aretransmitted one after the other without interruption. In Two-way mode, aftertransmitting each code, the gun waits for the Host answer message to be shown onthe display. Therefore, in Two-way transmission mode and normal batch mode, theStart Normal Batch Transmission barcode must be read after each code tocontinue, whereas with automatic batch mode just pull and release the trigger aftereach code.The code which has a transmission pending is shown on the display in reverse videoindicating that it cannot be deleted.5.8.7 Find Me (Dragon M131 only)If enabled, after a timeout of a few minutes in which Dragon™ M131 is not used, itenters stand-by mode and its green LED starts blinking in order to signal its location.5.9 DISPLAY PARAMETERS (SOME M131 MODELS ONLY)5.9.1 Display ModeThe user can control the gun display behavior according to the following selections:Normal mode: When a barcode is read with the gun:• The code is sent to the Host.• The gun display is not cleared. Therefore if any previous data was displayed onthe gun screen it remains.• There is no Local Echo to the gun display.Clear Display After Decode mode: When a barcode is read with the gun:• The code is sent to the Host.• The gun display is cleared. Therefore if any previous data was displayed on thegun screen it is cancelled and the screen remains blank.• There is no Local Echo of the code to the gun display.Local Echo mode: When a barcode is read with the gun:• The code is sent to the Host.• The gun display is cleared.• The code is also sent to the gun display (Local Echo).• The cursor is positioned after the last printed character on the gun display.Host messages sent to the gun are always written to the gun display.153
