Datalogic DS5100-X200 Reference Manual

Contents

Datalogic DS5100-X200 Reference Manual Manual pdf 22 page image

DS5100 REFERENCE MANUAL61STEP 4 – X-PRESS CONFIGURATIONX-PRESS is the intuitive Human Machine Interface designed to improve ease of installationand maintenance.Status and diagnostic information are clearly presented by means of the colored LEDs,whereas the single push button gives immediate access to the following relevant functions: AutoSetup to self-optimize and auto-configure readingperformance in demanding applications AutoLearn to self-detect and auto-configure forreading unknown barcodes (by type and length) Focus Lock to memorize the mechanical focusposition Test Mode with bar graph visualization to check staticreading performance EBC/Profinet-IO network selection to set the scanneras a Slave in an EBC network. (only for on-boardProfinet 2 port models).NOTE: When entering the X-PRESS interface on the DS5100-xx2x theOscillating Mirror remains in the default fixed position (0°) in order to makebarcode reading easier while performing the X-PRESS functions.The colors and meaning of the indicator LEDs are illustrated in the following table:LED Color DescriptionREADY Green Indicates the device is ready to operate. For Subzero models thisLED blinks during the warm-up phase.GOOD Green Confirms successful reading.TRIGGER Yellow Indicates the status of the reading phase. *COM Yellow Indicates active communication on main serial port. **STATUS Red Indicates a NO READ result.ETH2 Yellow Indicates connection to the on-board Profinet-IO network port 2.Not used on other models.ETH1 Yellow Indicates connection to the on-board Ethernet or on-boardProfinet-IO network port 1. Not used on Serial models.PWR Blue Indicates that the reader is connected to the power supply.* In On-Line mode the TRIGGER LED corresponds to the active reading phase signaled by the Presence Sensor.In Automatic and Continuous modes the TRIGGER LED is always on indicating that the reader is ready to read acode.** When connected to a Fieldbus network through a Host Interface Module inside the CBX500 or through a QLM,the COM LED is always active, even in the absence of data transmission, because of polling activity on theFieldbus network.During the reader startup (reset or restart phase), the first five LEDs blink for one second.