Datalogic DS5100-X200 Reference Manual

Contents

Datalogic DS5100-X200 Reference Manual Manual pdf 36 page image

DS5100 REFERENCE MANUAL2022.1.1 IndicatorsThe five LEDs on the side of the scanner (Figure A, B, C, D, E, 7) indicate the following:LED Color DescriptionREADY Green This LED indicates the device is ready to operate. For Subzeromodels this LED blinks during the warm-up phase.GOOD Green This LED confirms successful reading.TRIGGER Yellow This LED indicates the status of the reading phase. *COM Yellow This LED indicates active communication on main serial port. **STATUS Red This LED indicates a NO READ result.* In On-Line mode the TRIGGER LED corresponds to the active reading phase signaled by the Presence Sensor.In Automatic and Continuous modes the TRIGGER LED is always on indicating that the reader is ready to read acode.** When connected to a Fieldbus network through the CBX500, the COM LED is always active, even in theabsence of data transmission, because of polling activity on the Fieldbus network.During the reader startup (reset or restart phase), all the LEDs blink for one second.PWR (blue) This LED indicates that the reader is connected to the powersupply.ETH (yellow) This LED indicates connection to the on-board Ethernet orProfinet-IO network.2.2 ID-NETThe ID-NET network is a built-in high-speed interface dedicated forhigh-speed scanner interconnection. ID-NET is in addition to theMain and Auxiliary serial interfaces.The following network configurations are available: ID-NET Synchronized: Single station – multiple scannersID-NET interface allows local connection ofmultiple scanners reading different sides ofthe same target. All scanners share asingle presence sensor andactivate/deactivate simultaneously.At the end of each reading phase a singledata message is transmitted to the host.Thanks to ID-NET, data communicationamong scanners is highly efficient so thatan immediate result will be available.