Datalogic DS8100A Reference Manual

Also see for DS8100A: Reference manual Reference manual Reference manual

Contents

Datalogic DS8100A Reference Manual Manual pdf 34 page image

DS8100A2The OUT3 electrical features are given below:Maximum voltage ± 100 VCollector current (pulse) 240 mA Max.Collector current (continuous) 150 mA Max.R on 6 – 15 ΩR off > 500 ΩOff-state leakage current < 1 μAMaximum power dissipation 550 mW at 50°C (Ambient temperature).DS8100A USER INTERFACEVext 100 Vdc maxA/BB/AFigure 21 – Output 3 InterfaceThe command signal is filtered and generates a delay of about 50 μs for OUT1 and OUT2and 1 ms for OUT3.2.3.2 Lonworks Input/Output ConnectorA1 A2115scanner sideexternal view A1 A2115OUTPUT (female)INPUT (male)Figure 22 - Lonworks INPUT/OUTPUT ConnectorsThe following pinout is valid for the INPUT connector as well as for the OUTPUT connector.Lonworks INPUT/OUTPUT 17-pin Connector PinoutPin Name FunctionA1 GND supply voltage (negative pin)A2 VS supply voltage 20 to 30 vdc (positive pin)1 Shield A Cable shield A2 n.c. Not connected3 Shield B Cable shield B4 n.c. Not connected5 n.c. Not connected6 n.c. Not connected7 VS_I/O Supply voltage of I/O circuit8 Lon A+ Lonworks a line (positive pin)9 Lon A- Lonworks a line (negative pin)10 Lon B+ Lonworks b line (positive pin)11 Lon B- Lonworks b line (negative pin)12 SYS_I/O System signal13 SYS_ENC_I/O System signal14 n.c. Not connected15 Ref_I/O Reference voltage of I/O circuit18