Datalogic Gryphon I GBT4400 Product Reference Manual

Also see for Gryphon I GBT4400: Product reference guide Quick reference guide Product reference guide Quick reference guide Quick reference guide

Contents

Keyboard InterfaceProduct Reference Guide 263Intercharacter DelayThis parameter specifies the intercharacter delay between the end of one character and thebeginning of the next. The delay can be set within a range of zero (0) to 990 milliseconds in10ms increments. A setting of zero specifies no delay.To set the delay:1. Determine the desired setting in milliseconds.2. Divide the desired setting by 10 (setting is in 10ms increments). Pad the result with lead-ing zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.3. Go to page 47 and scan the ENTER/EXIT PROGRAMMING MODE bar code to enterProgramming Mode.4. Scan the bar code: SELECT INTERCHARACTER DELAY SETTING.5. Scan the appropriate two digits from the keypad in Appendix D, Keypad, that representthe duration which was determined in the steps above. You will hear a two-beep indica-tion after the last character.6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit ProgrammingMode.This completes the procedure. See Table 33 for some examples of how to set this feature.Table 33. Intercharacter Delay Setting ExamplesThis feature applies ONLY to the Keyboard Wedge interface.If you make a mistake before the last character, scan the CANCEL bar codeto abort and not save the entry string. You can then start again at thebeginning.STEP ACTION EXAMPLES1 Desired Setting 50ms 150ms 600ms 850ms2Divide by 10 (and pad withleading zeroes to yield two-digits)05 15 60 853 Scan ENTER/EXIT PROGRAMMING MODE4 Scan SELECT INTERCHARACTER DELAY SETTING5 Scan Two Characters FromAppendix D, Keypad ‘0’ and ‘5’ ‘1’ and ‘5’ ‘6’ and ‘0’ ‘8’ and ‘5’6 Scan ENTER/EXIT PROGRAMMING MODE