References266 Gryphon™ I GD44XX/GBT4400/GM440X4. Scan the appropriate two digits from the keypad in Appendix D, Keypad that representthe length setting which was determined in the steps above. You will hear a two-beep indi-cation after the last character.5. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit ProgrammingMode.This completes the procedure.Data EditingWhen a bar code is scanned, additional information can be sent to the host computer alongwith the bar code data. This combination of bar code data and supplementary user-defined datais called a “message string.” The Data Editing features can be used to build specific user-defineddata into a message string.There are several types of selectable data characters that can be sent before and after scanneddata. You can specify if they should be sent with all symbologies, or only with specificsymbologies. Figure 15 shows the available elements you can add to a message string:Figure 15. Breakdown of a Message StringIf you make a mistake, before the last character scan the CANCEL bar codeto abort and not save the entry string. You can then start again at thebeginning.CAUTIONIt is not recommended to use these features with IBM interfaces.Additional advanced editing is available. See the Advanced formatting fea-tures in the Datalogic Aladdin configuration software, or contact TechnicalSupport (as described on page 10) for more information.Prefix SuffixAIM IDLabel ID Label IDBar Code Data00 - 20 Characters (ASCII)Label ID Transmission:Enable this option totransmit the Label ID youconfigure for the scannedsymbology.AIM ID: This function is used to identify and display thecommon label identifier for its symbology. When enabled,this ID code will be transmitted before the scanned barcode data.OR...