Symbologies182 Gryphon™ I GD4100Code 39 — cont.Code 39 Set Length 2This feature specifies one of the barcode lengths for Code 39 Length Control. Length 2 is themaximum label length if in Variable Length Mode, or the second fixed length if in Fixed LengthMode. Length includes the barcode’s check, data, and full-ASCII shift characters. The lengthdoes not include start/stop characters.The length can be set from 1 to 50 characters. A setting of 0 specifies to ignore this length (onlyone fixed length).Follow these instructions to set this feature:1. Determine the desired character length (from 1 to 50 — or 0 to ignore this length). Padthe number with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20,etc.2. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter ProgrammingMode.3. Scan the barcode: SELECT CODE 39 LENGTH 2 SETTING.4. Scan the appropriate two digits from the keypad in Appendix E, Keypad, that represent thelength setting which was determined in the steps above. You will hear a two-beep indica-tion after the last character.NOTE5. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit ProgrammingMode.This completes the procedure. See Table 22 for some examples of how to set this feature.Table 22. Code 39 Length 2 Setting ExamplesSTEP ACTION EXAMPLES1 Desired Setting 00 (Ignore ThisLength) 07 Characters 15 Characters 50 Characters2 Scan ENTER/EXIT PROGRAMMING MODE3 Scan SELECT CODE 39 LENGTH 2 SETTING4 Scan Two Characters FromAppendix E, Keypad ‘0’ and ‘0’ ‘0’ and ‘7’ ‘1’ and ‘5’ ‘5’ AND ‘0’5 Scan ENTER/EXIT PROGRAMMING MODEIf you make a mistake, before the last character scan the CANCELbarcode to abort and not save the entry string. You can then startagain at the beginning.
