Scanning FeaturesProduct Reference Guide 37Scanning FeaturesScan ModeSelects the scan operating mode for the reader. Selections are:Trigger Single. When the trigger is pulled, scanning is activated until one of the followingoccurs:- Scanning Active Time has elapsed- a label has been read- the trigger is releasedThis mode is associated with typical handheld reader operation: when the trigger is pulled,scanning starts and the product scans until the trigger is released, or a label is read, or themaximum Scanning Active Time has elapsed.Trigger Hold Multiple . When the trigger is pulled, scanning starts and the product scans untilthe trigger is released or Scanning Active Time has elapsed. Reading a label does not disablescanning. Double Read Timeout prevents undesired multiple reads of the same label while in thismode.Trigger Pulse Multiple. When the trigger is pulled, continuous scanning is activated untilScanning Active Time has elapsed or the trigger has been released and pulled again. Double ReadTimeout1 prevents undesired multiple reads of the same label while in this mode.Flashing. The reader flashes 1 on and off regardless of the trigger status. Flash rate is controlledby Flash On Time and Flash Off Time. When Flash is ON the imager reads continuously; whenFlash is OFF scanning is deactivated.Always On. No trigger pull is required to read a barcode. Scanning is continually on. If thetrigger is pulled, the reader acts as if it is in Trigger Single Mode. Double Read Timeout1 preventsundesired multiple reads of the same label while in this mode.Stand Mode. No trigger pull is required to read a barcode. Scanning is turned on automaticallywhen an item is placed in the reader’s field of view. If the trigger is pulled, the reader acts as if itin single read mode. Double Read Timeout1 prevents undesired multiple reads while in thismode.Trigger Object Sense. This mode is similar to Stand Mode, except that a trigger pull is requiredto activate the decoder.1. Controlled by Flash On Time.
